English
Fitting the skirt
Replacing the Skirt
Replacing the Cutting
Blade
Removing the skirt
1
3
4
A
1
3
2
B
C
4
N
Push the skirt (3) into the slot in the
deflector until it can be engaged on
the lug (4).
Do not attempt to straighten or weld a
bent or cracked blade – it may break –
it must be replaced – see "Mounting the
Cutting Blade".
N
N
Fit the washer on the screw.
N
N
N
Loosen and remove the screw (1).
Remove the washer (2).
Insert the screw and tighten it down
firmly.
STIHL recommends you use only
original STIHL cutting blades – see
"Special Accessories".
Pull the skirt (3) off the lug (4) and
out of the deflector.
Do not resharpen the blade.
Position of skirt
Always replace the blade (1) when its
length (A) is no longer sufficient to
obtain the depth of cut (C) while
maintaining the required ground
clearance (B).
Balancing
5
3
To avoid out-of-balance:
N
Use the STIHL balancer (special
accessory) to check and rectify out-
of-balance or have this work done
by a servicing dealer – STIHL
recommends an authorized STIHL
servicing dealer.
N
Position the skirt (3) correctly in
relation to the depth wheel (5): The
wheel is on the left – the skirt must
project to the right.
2
4
FC 56 C
Categories | STIHL Straight Edger Manuals, Straight Edger Manuals |
---|---|
Tags | STIHL FC 56C |
Download File |
|
Language | English, Español |
Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Edger |
Document File Type | |
Publisher | stihl.com |
Wikipedia's Page | Stihl |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)