ENGINE REMOVAL AND INSTALLATION
8.
Pull the recoil starter rope through the hole in the
control panel (Figure 42). Next, slide the rope
onto and through the starter handle and make a
small knot. Slide the starter rope back into the
starter handle. Remove the knot in the starter
rope at the starter housing and allow the starter
rope to retract into the starter.
10. If your snowthrower is equipped with an electric
starter, install the starter to the engine mounting
bracket (Figure 44). Torque the starter mounting
bolts at the mounting bracket to 120 - 180 in·lbs.
Install the wire harness with the cable clamp to the
engine. Replace the starter motor tie down strap.
Finally, mount the switch and plug assembly to the
lower shroud.
Figure 42
0217-025
9.
On 20” models, slide the muffler into place on the
engine. Torque the muffler nuts to 90 - 120 in·lbs.
(Figure 43).
Figure 44
0217-027
Note: Do not over torque the nuts, you may crack
the engine block.
11. Belt Drive Units:
A. Torque the crankshaft engine mounting nut to
170 - 220 in·lbs. Then tighten the starter nut to
70 - 120 in·lbs (Figure 45).
Figure 43
0217-026
Figure 45
0217-028
4 - 4
Single Stage Snowthrower Service Manual
| Categories | Snow Blower Manuals, Toro Snow Blower |
|---|---|
| Tags | Toro 1028 Power Shift, Toro 1332 Power Shift, Toro 38014, Toro 38030, Toro 38079, Toro 38087, Toro 38400, Toro 38405, Toro 38513, Toro 38543, Toro 38558, Toro 38559, Toro 38574, Toro 624, Toro 824, Toro 828, Toro 924, Toro CCR 1000 |
| Model Year | 1978, 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Serial Number | 200000001 - 200999999 |
| Product Name | Toro CCR 1000 Snowthrower |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Snow Blower |
| Product Type | Snowthrower |
| Product Series | CCR 1000/2400/2500, Single Stage, Snowthrower |
| Swath | 20 inch |
| Discharge | Single Stage |
| Engine Manufacturer | Tecumseh |
| Engine Oil Type | Toro 2 cycle / NMMA-TCW3 |
| Engine Motor Model # | HSK635-1721A |
| Engine Motor Size | 3.5 hp |
| Engine Motor Type | 2 Cycle EPA1 |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)