Toro GTS 200 Overhead Valve Engine Lawn Mower Service Manual

3.
Disconnect fuel line at carburetor and clamp fuel line.
Remove three (3) screws holding fuel tank to blower
housing and screw and spacer holding tank to cylinder,
Fig. 69.
5.   Remove four (4) screws, two (2) from front and two (2)
from rear of blower housing, Fig. 71.
Note: Rewind starters used on these engines are riveted to
the blower housing. Replacement starters are supplied with
screws and nuts to replace the rivets for mounting starter.
Note: Some models have fuel tanks that are held on the
engine with a fuel tank mounting bracket. One screw holds
tank to bottom of fuel tank bracket. The other screw holds
tank to side of cylinder with a screw, rubber washer and
plastic spacer. Slide fuel tank up off fuel tank bracket.
1
1
1
1
Fig. 71 – Removing Blower Housing
1.
Screw
2
1
Disassemble Rewind Starter
Fig 69 – Removing Fuel Tank
Remove Rope
1.
Screw
2.   Fuel tank
1.
2.
Pull starter rope out as far as it will go.
4.
Remove screw holding oil fill tube to blower housing and
remove tube, Fig. 70.
While holding pulley and starter housing, pull pulley end
of rope out and untie knot at end of rope.
Note: Some engines have a fuel tank bracket mounted on
the rear of the engine that must be removed before the
blower housing can be removed. 21” commercial mower
engines use a four (4) quart fuel tank.
3.
4.
Remove rope and handle from starter.
Slowly release pulley to release spring tension.
Inspect Rope
2
1.
2.
3.
Inspect rope for fraying or broken strands.
Replace if frayed or broken strands are found.
1
3
If re-using old rope, burn each end of rope with an open
flame.
1
4.
Wipe with waste cloth, using caution, while it is still hot,
to prevent swelling and unravelling.
Note: When installing a new rope, check parts list to be
sure correct diameter and rope length is used. The service
replacement rope is cut to length as required: See
Table No. 1.
Fig. 70 – Removing Oil Fill Tube
Table No. 1
1.
2.
Screws (2)
3.   Dipstick and oil fill tube
Blower housing and
rewind starter
Rewind Starter Rope Specifications
Length
Rope Size
Inches
Meters
#5
88–5/8
2.25
Rewind Starter
34
GTS 200
Product Specification
CategoriesLawn Mower Manual, Parts and Accessories Manuals, Toro Lawn Mower Manual
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 62 pages
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website