Electrical System Quick Checks
Battery Test (Open Circuit Test)
Use a multimeter to measure the voltage between the
battery terminals.
Voltage Measured
Battery Charge Level
Fully charged (100%)
75% charged
12.68
12.45
12.24
12.06
11.89
v (or higher)
Set the multimeter to the DC volts setting. The battery
should be at a temperature of 60o to 100o F (16o to 38o
v
v
v
v
50% charged
C). The ignition key should be in the OFF position and
all accessories turned off. Connect the positive (+) me-
ter lead to the positive battery post and the negative (--)
meter lead to the negative battery post. Use the table to
the right to determine charge level of the battery.
25% charged
0% charged
NOTE: This test provides a relative condition of thebat-
tery. Load testing of the battery will provide additional
and more accurate information.
Charging System Test
This is a simple test used to determine if the charging
system is functioning. It will tell you if the charging sys-
tem has an output, but not its capacity.
Acceptable voltage increase:
Initial Battery Voltage
= 12.25 v
= 12.80 v
= +0.55 v
Battery Voltage after 3 Minute Charge
Difference
Use a multimeter set to the DC volts position. Connect
the positive (+) meter lead to the positive battery post
and the negative (--) meter lead to the negative battery
post. Leave the multimeter test leads connected to the
battery and record the battery voltage.
NOTE: Upon starting the engine, the battery voltage
will drop and then should increase once the engine is
running.
NOTE: Depending upon the condition of the battery
charge and battery temperature, the charging system
voltage will increase at different rates as the battery
charges.
Start the engine and run at 2700 RPM (high idle). Allow
the battery to charge for at least 3 minutes. Record the
battery voltage.
After allowing the engine to run for at least three (3) min-
utes, battery voltage should be at least 0.5 volts higher
than initial battery voltage (see example in table to the
right).
NOTE: While engine is running, if battery voltage ex-
ceeds 16 volts, the regulator in the charging system
should be inspected.
After allowing the engine to run for at least three (3) min-
utes, if battery voltage does not increase at least 0.5
volts, additional testing of the battery and/or charging
system should be performed.
Groundsmaster 580--D
Page 8 -- 7
Electrical System (S/N 30101 & Up) (Rev. E)
Product Specification
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Groundsmaster 30581, Toro Groundsmaster 580 D |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |