Toro Lawn-Boy Lawn Mower Drive System Manual

WORM DRIVE TRANSMISSION
5.
If the bearing in the cover is being replaced, use tool
9.   Fill the transmission with gear oil AFTER it is
installed in the mower. The top of this transmission is
not sealed. It will leak if tipped on its side (Fig. 020).
P/N 27-0490 to press it in place. This bearing only
has one seal. Install the bearing such that the seal
is visible from the top of the cover and the open side
faces the gears. Press the bearing in until it is fully
seated in the case (Fig. 019).
A
A
B
Fig 020
3428-0166
A.   Fill/Check
B.   Plug
Fig 019
3428-0159
A.   Tool P/N 27-0490
Controls
There are two control cables used with this system. One
cable operates the engine kill switch and flywheel brake;
the other controls the transmission.
6.
7.
Install worm shaft in bearing.
Use a new gasket. Install the cover on the bottom
case and start the 4 self-tapping screws. Do not fully
tighten them.
8.
Install the front and rear roll pins to align the cover
and case. Then secure the 4 self-tapping screws.
WPM Drive Systems Manual
1-9
Product Specification
CategoriesLawn Mower Manual, Lawn-Boy Lawn Mower Manuals, Toro Lawn Mower Manual
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 144 pages
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website