SINGLE SPEED BEVEL GEAR TRANSMISSION
Assembly Tips
3. Install the transmission bearings with the flange
facing the gear (Fig. 054).
1.
The same axle is used for both front and rear drive
versions. There are two holes in the axle about one
inch apart. Front wheel drive transmissions use the
hole in the axle that is about 5 ¾” (14.6cm) from the
end or closest to the center of the axle (Fig. 052).
Slip the gear on such that the teeth and longest hub
face the longer end of the axle. Drive the pin into
place. A double check is that neither of the pin holes
should be visible when the gear is installed.
Fig 054
MVC-470
4.
5.
6.
If the input bearing was removed, press the new one
in until it bottoms in the case.
Fill the transmission case approximately 2/3 full with
#2
lithium base grease.
Assemble the bearing, bearing retainer, height of
cut plate, spring arm and pivot arm. Use two clamps
or vise grips to compress the assembly so the snap
ring can be installed.
Fig 052
MVC-466
2.
Install the trust washer on the side of the gear with
the shorter hub, away from the gear teeth (Fig. 053).
Note: Install the snap ring with the sharp edge
facing away from the spring arm.
Fig 053
MVC-468
3-8
WPM Drive Systems Manual
| Categories | Lawn Mower Manual, Lawn-Boy Lawn Mower Manuals, Toro Lawn Mower Manual |
|---|---|
| Download File |
|
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)