Toro Lawn-Boy Lawn Mower Drive System Manual

SINGLE SPEED BEVEL GEAR TRANSMISSION
Axle Assembly Tips
3.   Install the transmission bearings with the flange
facing the gear (Fig. 085).
1.
The same axle is used for both front and rear wheel
drive models. There are two holes in the axle about
one inch apart.
Rear wheel drive models use the hole about 4-3/4”
(12cm)
from the end. Slip the gear on such that the
teeth and the longest hub face the short end of the
axle. Drive the pin into place. A double check is that
neither of the pin holes should be visible when the
gear is installed (Fig. 084).
Fig 085
MVC-470
4.
5.
Fill the transmission approximately 2/3 full with #2
Lithium base grease (1.5 oz or 43gm).
Assemble the bearing, bearing retainer, HOC plate,
spring arm, and pivot arm. Use two vise grips or
clamps to compress the assembly so the snap ring
can be installed (Fig. 086).
Fig 084
MVC-469
Note:  Install the snap ring with the sharp edge
facing away from the spring arm.
A.   Gear
B.   Thrust washer
2.
Install the thrust washer on the side of the gear with
the shortest hub, away from the gear teeth (Fig.
084).
Fig 086
MVC-748
WPM Drive Systems Manual
3-17
Product Specification
CategoriesLawn Mower Manual, Lawn-Boy Lawn Mower Manuals, Toro Lawn Mower Manual
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 144 pages
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website