SINGLE SPEED BEVEL GEAR TRANSMISSION
Transmission Disassembly
Transmission Assembly & Installation
1.
Remove the 4 screws holding the cover on the
transmission. The axle, bearings, and bevel gear
can be lifted out (Fig. 106).
Assemble in reverse order. See Axle Assembly and
Installation Tips following.
Axle Assembly Tips
1.
The same axle is used for both front and rear wheel
drive models. There are two holes in the axle about
one inch apart.
Rear wheel drive models use the hole about 4-3/4”
(12cm)
from the end. Slip the gear on such that the
teeth and the longest hub face the short end of the
axle. Drive the pin into place. A double check is that
neither of the pin holes should be visible when the
gear is installed (Fig. 108).
Fig 106
MVC-462
2.
3.
4.
Since the pulley was previously removed, the input
shaft will now slip out of the transmission case.
If the input bearing is to be removed, press it out
now.
Slide the bearings and thrust washer off the axle.
Drive the roll pin out and the bevel gear can then be
removed (Fig. 107).
Fig 108
MVC-469
Fig 107
MVC-470
3-24
WPM Drive Systems Manual
| Categories | Lawn Mower Manual, Lawn-Boy Lawn Mower Manuals, Toro Lawn Mower Manual |
|---|---|
| Download File |
|
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)