4.
Position coring head to allow alignment of both sides
of H−frame to pivot shaft holes in coring head frame.
Slide pivot shaft through coring head frame and H−
frame. Secure pivot shaft to coring head frame with car-
riage screw and flange nut.
1
3
5.
Position upper link assemblies to hitch frame and
coring head frame. Make sure that link assemblies (Fig.
have the groove installed in the same direction. Se-
8.170”
to 8.230”
31)
(208
to 209 mm)
cure upper link rod ends to machine with lock washer
and hex nut.
2
6.
Install compression spring(s) to coring head frame:
Figure 31
A. With compression spring tool (see Special Tools)
compressing the spring, position upper end of spring
to hitch frame and then slide bottom of spring to cor-
ing head frame spring bracket.
1.
2.
Rod end (RH threads)
Rod end (LH threads)
3.
Link groove
B. Loosen lower nut on threaded rod to allow spring
(item 2) to extend.
C. Remove compression spring tool threaded rod,
washers and nuts from spring cups (item 1) and
spring.
D. If working on ProCore 864, repeat for second
spring.
7.
Install pulley shield and front cover to machine (see
Cover Installation in the Service and Repairs section of
Chapter 3 − Chassis).
8.
9.
Install rear hood to machine.
Adjust aerator to desired depth setting.
Coring Head
Page 4 − 30
ProCore 864/1298
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro ProCore 1298, Toro ProCore 864 |
Download File |
|
Document Type | Catalog |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)