ASSEMBLY
CHECK THE TIRES
REMOVE SNOWTHROWER FROM PALLET
Check tires for damage. Check the air pressure in the tires with an accurate
gauge. See the sidewall of the tire for the proper inflation.
1.
2.
Remove straps that secure snowthrower to pallet.
Remove snowthrower from pallet.
IMPORTANT: DO NOT back over cable or loose parts.
CAUTION: Avoid Injury! Explosive separation of tire
and rim parts is possible when they are serviced
incorrectly.
3. Check level of skid shoes to ensure the same height on each side.
•
Do not attempt to mount a tire without the proper
equipment and experience to perform the job.
Do not inflate the tires above the recommended pressure.
Do not weld or heat a wheel and tire assembly. Heat can
cause an increase in air pressure resulting in an
explosion. Welding can structurally weaken or deform the
wheel.
Do not stand in front or over the tire assembly when
inflating. Use appropriate tool that allows you to stand to
one side.
SECURE WITH ZIP TIES
•
•
1.
Route deflector cable to right side of engine and between belt cover
and chute.
2.
3.
Secure deflector cable to oil dipstick with zip tie.
Secure deflector cable and wiring harness above bend of lower handle
with zip tie.
•
NOTICE: Check side of tire for maximum tire pressure. DO
NOT exceed maximum.
12
| Categories | Murray Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Murray 1695719 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)