MAINTENANCE
SERVICE RECOMMENDATIONS
FIRST
5
HOURS
BEFORE
EACH
USE
AFTER
EACH
USE
EVERY
5
HOURS
EVERY
10
HOURS
EVERY
25
HOURS
BEGINNING
EACH
SEASON
BEFORE
STORAGE
PROCEDURE
Check to Make Sure
Auger Blade Stops Within
Seconds After Right
5
✓
Control Lever is Released
SAFETY
Lubricate Control Levers
and Linkages
✓
✓
✓
Check Snowthrower for
Loose Hardware
✓
✓
✓
Lubricate Hex Shaft and
Chains
✓
✓
Lubricate Auger Shaft
Fittings
✓
SNOWTHROWER
Lubricate Chute Rotation
Gear and Deflector
Mechanism
✓
Remove All Snow and
Slush off Snowthrower to
Prevent Freezing of Auger
or Controls
✓
Check Tire Pressure
✓
✓
Oil, Check
✓
✓
✓
✓
Oil, Change
✓
ENGINE
Check and Replace
Spark Plug
✓
NOTE: The warranty on this snowthrower does not cover items
that have been subjected to operator abuse or negligence. To
receive full value from the warranty, operator must maintain
snowthrower as instructed in this manual.
CAUTION: Do not allow grease or oil to contact the
rubber friction wheel or the disc drive plate. If the
disc drive plate or friction wheel come in contact with
grease or oil, damage to rubber friction wheel will
result.
The above Service Recommendations are supplied to assist the opera-
tor to properly maintain the snowthrower.
NOTICE: If grease or oil comes into contact with the disc drive
plate or friction wheel, make sure to clean plate and wheel
thoroughly with an alcohol base solvent.
21
| Categories | Murray Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Murray 1695719 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)