MAINTENANCE
AUGER SHEAR BOLT REPLACEMENT
The augers are secured to the auger shaft with special bolts that are de-
signed to break if an object becomes lodged in the auger housing. Use of a
harder bolt will reduce the protection provided by the shear bolt.
A
WARNING: To insure safety and performance levels,
only original replacement shear bolts should be used.
C
1.
2.
Stop the engine, disengage all controls, disconnect the spark plug
lead wire, and make sure all moving parts have stopped.
Align the hole in the auger with the hole in the auger shaft. Install new
shear bolt (A, Figure 36), spacer (B) and locknut (C) found in the
toolbox located on the belt cover.
D
B
NOTE: The spacer fits into the larger hole in the auger tube.
Traction Control Cable
Figure 34
A
B
“A”
C
Replacing Auger Shear Bolt
Figure 36
A
Checking Adjustment of Traction Control Cable
Figure 35
CHECK THE TIRES
Check tires for damage. Check the air pressure in the tires with an accurate
gauge (see Figure 37).
CAUTION: Avoid Injury! Explosive separation of tire
and rim parts is possible when they are serviced
incorrectly.
•
Do not attempt to mount a tire without the proper
equipment and experience to perform the job.
•
•
Do not inflate the tires above the recommended pressure.
Do not weld or heat a wheel and tire assembly. Heat can
cause an increase in air pressure resulting in an
explosion. Welding can structurally weaken or deform the
wheel.
Checking Tire Air Pressure
Figure 37
•
Do not stand in front or over the tire assembly when
inflating. Use appropriate tool that allows you to stand to
one side.
NOTICE: Check side of tire for maximum tire pressure. DO
NOT exceed maximum.
28
| Categories | Murray Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Murray 1695719 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)