Traction Switch 1 and 2 Replacement and Adjustment (Fig. 26)
1.
Disconnect wires from switch terminals.
2.
Have a helper push traction bail down into either
FORWARD or REVERSE position or disconnect exten
sion spring; this will take switch arm tensionoffofswitch.
Loosen two (2) screws and remove switch.
3
3.
switch. DO NOT over-tighten screws as the switch case
could break.
Have a helper push traction bail down and Install new
1
2
4.
Reconnect wires to new switch. Make sure one wire
is connected to “COMMON” terminal, and one wire is
connected to N.O. terminal (traction switch 1) or N.C.
terminal (traction switch 2).
Figure 26
IMPORTANT: Traction switch 1 and 2 have three (3)
terminals. If the two (2) wires are not connected to
the “COMMON” and “N.O.” terminals on traction
switch 1 and “COMMON” and “N.C.” terminals on
traction switch 2, the safety interlock circuit will not
function properly.
1. Traction switch 1 – N.O. (gray & black wires)
2. Traction switch 2 – N.C. (orange & yellow wires)
3. Switch tab
CAUTION
If the wires are not correctly installed to trac�
tion switch 1, the engine could start with the
traction bail in forward or reverse.
5.
Coat switch terminals and wires with skin-over
grease.
6.
Loosen two (2) screws and adjust switch tab so
switches are actuated, but not bottomed out, when
pump control is in neutral.
Hydroject 3010
Page 5 - 25
Repairs
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Hydroject 3010 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)