Component Testing
For accurate resistance and/or continuity checks, elec-
trically disconnect the component being tested from the
circuit (e.g. unplug the switch connector before doing a
continuity check on switch).
CAUTION
When testing electrical components for continu-
ity with a multimeter (ohms setting), make sure
that power to the circuit has been disconnected.
Ignition Switch
The engine mounted ignition (key) switch used on the
ProForce Debris Blower has three positions (OFF, RUN
and START) (Fig. 5). The switch terminals are posi-
tioned as shown in Figure 6.
OFF
45 o
RUN
Testing
45 o
1.
2.
nect the negative battery cable from the battery terminal
(see Battery Service in the Service and Repairs section
of this chapter). Position disconnected negative cable
away from the negative battery terminal.
Make sure that ignition switch is OFF.
START
To prevent unexpected machine operation, discon-
Figure 5
3.
ignition switch (see the Kohler Engine Service Manual
at the end of Chapter 3 -- Engine).
Remove engine blower housing to gain access to
G
S
R
B
4.
5.
Unplug wire harness connectors from switch.
M
A
The circuitry of the ignition switch is shown in the
chart in the right column. With the use of a multimeter
(ohmssetting),theswitchfunctionsmaybetestedtode-
termine whether continuity exists between the various
terminals for each switch position.
Figure 6
6.
testing.
Connect the harness connectors to the switch after
POSITION
OFF
CIRCUIT
G + M + A
B + A + R
B + S
7.
Engine Service Manual at the end of Chapter 3 -- En-
gine).
Install blower housing onto engine (see the Kohler
RUN
START
8.
Connect negative battery cable to negative battery
terminal. Tighten nut that secures battery cable from 10
to 15 ft--lb(14 to 20 N--m).Make sure that battery cover
is secured.
ProForce Debris Blower
Page 4 -- 9
Electrical System
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Download File |
|
Document Type | Catalog |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)