GAS POWER SHOVEL
COMPRESSION TEST
5.
Fully extend the recoil starter rope and tie a knot
in the rope at the starter idler pulley (Figure 219).
Compression Test Procedures
1.
Install the compression gauge into the spark plug
hole. IMPORTANT: Be certain that no more than
1/2” of the gauge is threaded into the cylinder as
damage to the piston may result.
2.
3.
Pull the starter rope several times to obtain the
highest compression reading.
If the compression reading is below 100 psi (689
kPa), cylinder, piston, or ring damage should be
suspected. If so damaged, a new engine short
block should be installed.
ENGINE REMOVAL
Figure 219
0406-036
1.
2.
Completely drain all fuel from the fuel tank.
6.
Thread the knot at the end of the recoil starter
rope through the side of the rope handle and untie
the knot.
Remove upper shroud (Figure 218). Refer to
"Removing The Upper Shroud" on page 9 - 4.
7.
8.
Remove the choke linkage, fuel line, and primer
hose from the carburetor.
Disconnect the lead wires from the On/Off switch.
Figure 218
0406-035
3.
4.
Place the fuel tank cap back on the fuel tank.
Disconnect the spark plug high tension wire.
9 - 16
Single Stage Snowthrower Service Manual
| Categories | Snow Blower Manuals, Toro Snow Blower |
|---|---|
| Tags | Toro 1028 Power Shift, Toro 1332 Power Shift, Toro 38014, Toro 38030, Toro 38079, Toro 38087, Toro 38400, Toro 38405, Toro 38513, Toro 38543, Toro 38558, Toro 38559, Toro 38574, Toro 624, Toro 824, Toro 828, Toro 924, Toro CCR 1000 |
| Model Year | 1978, 1992, 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Serial Number | 200000001 - 200999999 |
| Product Name | Toro CCR 1000 Snowthrower |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Snow Blower |
| Product Type | Snowthrower |
| Product Series | CCR 1000/2400/2500, Single Stage, Snowthrower |
| Swath | 20 inch |
| Discharge | Single Stage |
| Engine Manufacturer | Tecumseh |
| Engine Oil Type | Toro 2 cycle / NMMA-TCW3 |
| Engine Motor Model # | HSK635-1721A |
| Engine Motor Size | 3.5 hp |
| Engine Motor Type | 2 Cycle EPA1 |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)