Glow Controller
The controller is attached to the electric panel under the
operator seat.
5. If any of the conditions in Step 3 are not met or power
to terminal 1 exists and any of the other conditions in
Step 4 are not met:
NOTE: Refer to see Chapter 8 – Electrical Diagrams
when troubleshooting the glow controller.
A. Verify continuity of the circuitry from the battery to
the glow relay and glow plugs (see Chapter 8 – Elec•
trical Diagrams).
Controller Operation
1.
tion, the controller energizes the glow plugs and lights
up the glow lamp for approximately 6 seconds.
When the ignition switch is placed in the RUN posi•
B. Verify continuity of the circuitry from the battery to
ignition switch, glow controller, glow lamp, glow
relay, and ground (see Chapter 8 – Electrical Dia•
grams).
2.
When the ignition switch is held in the START posi•
tion, the glow plugs will energize while the switch is held
in START and the glow lamp will not light.
C. Replace parts as necessary.
6.
noid.
Connect electrical connector to the fuel stop sole•
3.
RUN, the glow plugs will de–energize and the glow lamp
will remain off.
When the ignition switch is released from START to
2
Controller Checks
1.
Make sure there is power from the battery.
3
6
2.
noid to prevent the engine from starting.
Disconnect electrical connector to the fuel stop sole•
2
1
5
4
3.
Place ignition switch in the RUN position. Verify the
following while in the RUN position:
A. Glow indicator lamp is on.
B. Glow relay is energized.
1
3
C. Glow plugs are energized.
D. Glow indicator lamp goes out and glow plugs de–
energize after approximately 6 seconds.
Figure 39
1.
2.
Glow controller end view
3.
Side view
Top view
4.
Place ignition switch in the START position. Verify
the following while in the START position:
A. Glow indicator lamp is out.
B. Glow relay is energized.
C. Glow plugs are energized.
D. Power exists at terminal 1 of the glow controller.
NOTE: If there is no power to terminal 1 of the glow con•
troller, verify continuity of the circuitry from the ignition
switch to the controller and perform Step 4 again (see
Chapter 8 – Electrical Diagrams).
Electrical System
Multi Pro 5700–D
Page 5 – 24
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro 5700 D |
| Download File |
|
| Document Type | Catalog |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)