Toro 04130SL Rev C Service Manual Multi Pro 5700 D Preface Publication

Removal (Fig. 26)
Park machine on  a level surface,  stop engine, en•
4.  Install new hydraulic oil filter and fill hydraulic reser•
voir with correct oil (see Operator’s Manual).
1.
gage parking brake, and  remove key from the ignition
switch.
5.  Properly fill hydraulic system (see Charge Hydraulic
System in the Service and Repairs section of this chap•
ter).
2.
To prevent contamination of hydraulic system during
gear pump removal, thoroughly clean exterior of pump
assembly.
6.  Stop engine and check for hydraulic oil leaks. Check
hydraulic reservoir oil level.
CAUTION
2
Rotate steering wheel and depress traction ped•
al in both forward and reverse to relieve hydrau•
lic  system pressure  and to  avoid  injury from
pressurized hydraulic oil.
3.
Operate  all hydraulic  controls to  relieve  hydraulic
system pressure.
4.
Installing Hydraulic System Components at  the begin•
ning of the Service and Repairs section of this chapter.
Read the  General  Precautions for  Removing and
1
Figure 27
NOTE:  To ease  reassembly,  tag  hydraulic  hoses to
show their correct position on the gear pump.
1.
Gear pump
2.
Piston pump
5.
Put drain pan below the gear pump. Remove hydrau•
lic hoses and fittings connected to gear pump. Put plugs
or  caps on  disconnected  hydraulic  hoses  and open
ports of pump to prevent contamination of the system.
6.
27).
Support the gear pump to prevent it from falling (Fig.
Remove two (2) cap screws and flat washers retain•
ing gear pump to piston pump.
7.
Carefully pull gear pump from piston pump and lower
it out of the machine. Locate and retrieve o–ring from be•
tween pumps.
Installation (Fig. 26)
1.
Lubricate new o–ring and  position it to gear pump.
Carefully raise gear pump  and position it to the piston
pump.
2.
Align spline  teeth and slide  gear pump input  shaft
into piston pump coupling.  Support gear pump to pre•
vent it from falling while installing two (2) cap screws and
flat washers securing gear pump to piston pump.
3.
Remove plugs or caps from disconnected hydraulic
hoses and  ports of the  gear pump. Lubricate  new o–
rings and install fittings and hoses to correct location on
gear pump.
Multi Pro 5700–D
Page 4 – 31
Hydraulic System
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 212 pages
Document TypeCatalog
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website