Vehicle Status Light
The vehicle status light is located on the control panel
(Fig. 24). During normal operation, the status light
should be continuously illuminated. A vehicle electrical
problem will be identified by a flashing status light.
The vehicle status light and LED on the vehicle control-
ler should have the same condition (off, illuminated or
flashing). If the vehicle status light does not illuminate
when the on/off switch is turned ON, check the LED on
the vehicle controller to make sure it is illuminated. If the
controller LED is illuminated and the vehicle status light
is not illuminated, check the vehicle status light and cir-
cuit wiring.
1
See Controller (in this section) and your Operator’s
Manual for information on a flashing vehicle status light.
Figure 24
1.
Vehicle status light
Testing
1.
from switch.
Make sure on/off switch is turned OFF. Remove key
1B (–)
2.
Disconnect wire harness from vehicle status light.
NOTE: The vehicle status light is a 12 volt DC compo-
nent. Do not test the light using jumper wires from the
vehicle battery pack (48 VDC).
1A (+)
3.
Figure 25. Correctly connect 12 VDC source to the light
terminals.
The terminals for the light are marked as shown in
Figure 25
4.
the light and reconnect wire harness. Replace status
light if needed.
Light should illuminate. Remove voltage source from
Workman e2050/e2065
Electrical System (Rev. B)
Page 3 – 17
Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
---|---|
Tags | Toro Workman E2050, Toro Workman E2065 |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Product Type | Walk Behind Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)