7.
Anytime the machine is parked (short or long term),
8. Do not park on slopes unless wheels are chocked or
blocked.
install the service latch to secure the coring head in the
raised position. This eliminates the risk of the coring
head accidentally lowering to the ground.
Maintenance and Service
1.
Before servicing or making adjustments, position
11.Do not overspeed the engine by changing governor
setting. To assure safety and accuracy, check maximum
engine speed with a tachometer.
machine on level surface, raise coring head, set parking
brake, stop engine and remove key from the ignition
switch. Install the service latch to secure the coring head
in the raised position.
12.Shut
engine off before checking or adding oil to the
engine crankcase.
2.
keeping all nuts, bolts and screws tight.
Make sure machine is in safe operating condition by
13.Disconnect
battery before servicing the machine.
Disconnect negative battery cable first and positive bat•
tery cable last. If battery voltage is required for trouble•
shooting or test procedures, temporarily connect the
battery. Reconnect positive battery cable first and nega•
tive battery cable last.
3.
where there is an open flame, such as near a water heat•
er or furnace.
Never store the machine or fuel container inside
4.
Make sure all hydraulic line connectors are tight and
all hydraulic hoses and lines are in good condition be•
fore applying pressure to the hydraulic system.
14.Battery acid is poisonous and can cause burns.
Avoid contact with skin, eyes and clothing. Protect your
face, eyes and clothing when working with a battery.
5.
Keep body and hands away from pin hole leaks in hy•
draulic lines that eject high pressure hydraulic fluid. Use
cardboard or paper to find hydraulic leaks. Hydraulic
fluid escaping under pressure can penetrate skin and
cause injury. Hydraulic fluid accidentally injected into
the skin must be surgically removed within a few hours
by a doctor familiar with this form of injury or gangrene
may result.
15.Battery gases can explode. Keep cigarettes, sparks
and flames away from the battery.
16.At
the time of manufacture, the machine conformed
to all applicable safety standards. To assure optimum
performance and continued safety certification of the
machine, use genuine Toro replacement parts and ac•
cessories. Replacement parts and accessories made
by other manufacturers may result in non-conformance
with the safety standards, and the warranty may be
voided.
6.
Before disconnecting any hydraulic component or
performing any work on the hydraulic system, all pres•
sure in system must be relieved. See Relieving Hydrau•
lic System Pressure in the General Information section
of Chapter 4 – Hydraulic System.
17.When
changing tires or performing other service,
use correct blocks, hoists and jacks. Make sure ma•
chine is parked on a solid level floor such as a concrete
floor. Prior to raising the machine, remove any attach•
ments that may interfere with the safe and proper raising
of the machine. Always chock or block wheels. Use jack
stands or solid wood blocks to support the raised ma•
chine. If the machine is not properly supported by blocks
or jack stands, the machine may move or fall, which may
result in personal injury (see Jacking Instructions).
7.
sired, contact an Authorized Toro Distributor.
If major repairs are ever needed or assistance is de•
8.
head: wear gloves and use caution.
Use care when checking or servicing the coring
9.
free of excessive grease, grass, leaves and dirt.
To reduce potential fire hazard, keep engine area
10.If
engine must be running to perform maintenance or
make an adjustment, keep hands, feet, clothing and oth•
er parts of the body away from all moving machine parts.
Keep bystanders away.
ProCore 648
Safety
Page 1 – 3
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro 648 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)