Component Testing
For accurate resistance and/or continuity checks, elec-
trically disconnect the component being tested from the
circuit (e.g. unplug the ignition switch connector before
doing a continuity check on the switch).
CAUTION
When testing electrical components for continu-
ity with a multimeter (ohms setting), make sure
that power to the circuit has been disconnected.
NOTE: See the Briggs and Stratton Repair Manual for
4
Cycle, V--Twin Cylinder, OHV Head Engines (Work-
man MDX) or the Kohler Service Manual for Command
Pro CS Series Engines (Workman MD) for additional
component testing information.
Ignition Switch
The ignition switch used on the Workman has six (6)
switchterminals andthree(3)keyswitch positions.Only
two of the positions are used (OFF and RUN). The
switch terminals are identified as shown in Figure 5.
RUN
NOT
o
45
45o
OFF
USED
Testing
A
F
The circuitry of the ignition switch is shown in the chart
below. With the use of a multimeter (ohms setting), the
switch functions may be tested to determine whether
continuity exists between the various switch terminals
for each key position. Verify continuity between switch
terminals.
B
E
C
D
FRONT VIEW
REAR VIEW
Figure 5
POSITION
OFF
CIRCUIT
D + E + F
A + C + F
ON
Electrical System
Page 6 -- 8
Workman MD/MDX
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)