Hydraulic Motor Installation
1.
Install drive plate shield onto the reel drive motor
flange. Be sure the widest portion of the shield is at the
top (Fig. 13).
IMPORTANT:Make sure motor pulley set screws are
tight on the motor shaft before installing the motor
onto the cutting unit (Fig. 14).
2.
Insert reel drive motor pulley through the housing,
and slip cutting unit drive belt over the pulley (Fig. 13).
Note:
Proper belt tension is achieved when the belt
deflects about 1/8 inch (3 mm) at the mid−point when 7
lb (31 N) of force is applied.
3.
Insert two (2) reel drive motor mounting bolts (heads
Figure 13
2.
on the inside of the drive housing with flat washer on the
top bolt through the reel motor flange holes. Thread
locknuts onto the bolts. Rotate reel motor upward in the
slotted hole in the housing to tension the drive belt.
Tighten fasteners to 25 ft−lbs (34 Nm). NOTE: (Fig. 15).
1.
Drive plate shield
Reel drive motor flange
IMPORTANT:Rotate motors by hand only. Never
place a bar between hose fittings on the hydraulic
motors; motor damage may result.
4.
Install gasket and drive housing cover after making
sure the ends of the gasket are at the bottom of the hous-
ing to allow for drainage.
Figure 14
IMPORTANT:When hydraulic motors have been
mounted to the cutting units, make sure hydraulic
hoses lay flat and do not contact the frame of the
machine when the cutting units are in the raised
position. There should also be sufficient slack so
hoses are above and not in contact with the floata-
tion kit. If hoses appear twisted once the hydraulic
motors have been mounted and the belts tightened,
loosen swivel nuts at the motor and reposition
hoses. This can greatly increase the life of the
hoses. With cutting units down, all cutting unit
hoses should have a flat natural lay and be free from
twist.
1.
2.
Hydraulic motor
Motor pulley
3.
Drive belt
2
Note:
Refer to the Traction Unit Operator’s Manual for
instructions on setting the adjustable hydraulic counter-
balance.
Figure 15
2.
1.
Mounting bolts
Drive housing
Reelmaster 4000−D
Page 7 − 9
Cutting Units
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro 4000 D, Toro 98958SL |
| Download File |
|
| Document Type | Catalog |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)