Toro 98958SL Rev C Service Manual Reelmaster 4000 D Preface Publication

TEST NO. 1: Check Traction Circuit Working and Relief Pressures
Procedure for Working Pressure Check:
1.
Install a 10,000 psi gauge  into the quick disconnect
test port for the function to be checked.
2
3
NOTE:  If the  machine is  equipped with  4WD, check
working pressure in both 2WD and 4WD modes.
2.
Operate the unit while monitoring gauge.
RANGE OF TESTER READINGS:  50 − 5200 PSI
NOTE:  Typical  working   pressure   during   operation
while going uphill, would be approximately 4000 PSI in
2WD and 2500 PSI in 4WD.
1
3.
traction circuit relief pressure check.
If working  pressure is too low  in 2WD, perform  the
Figure 15
1.
2.
Reverse test port
3.
Forward test port
Front wheel motor (RH)
NOTE:  If pressure is good in 2WD but to low in  4WD,
check the cartridge valve seals in the 4WD valve block.
If 4WD pressure is low after making repairs to the valve
block the rear  wheel motor(s) should be  suspected of
wear and  inefficiency. Maximum allowable  bypass for
each rear wheel motor is 2 GPM.
Procedure for Relief Pressure Check:
1.
Hydraulic oil must be at operating temperature.
2.
Install a 10,000 psi gauge into the traction circuit quick
disconnect for the function to be checked.
3.
Set traction pedal stop for minimum ground speed (1
mph).
4.
Start the engine and move throttle to full speed (2500
rpm) and release the parking brake.
5.
Carefully drive the machine into position so it will push
against a strong wall or other immovable obstacle. Con-
tinue an attempt to go forward with the machine against
the obstacle and read the pressure gauge.
TESTER  READING   TO  BE   APPROXIMATELY
5000
− 5200 PSI
6.
If traction  pressure  is too  low, inspect  the  traction
pump check valves and relief valves. Clean or replace
relief valve(s)  or check valves  as necessary. If  check
valves and relief valves are in good condition, the trac-
tion pump and / or motors should be suspected of wear
and inefficiency.
Reelmaster 4000−D
Page 4 − 31
Hydraulic System
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 188 pages
Document TypeCatalog
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website