GAS POWER SHOVEL
COMPRESSION TEST
5.
Fully extend the recoil starter rope and tie a knot
in the rope at the starter idler pulley (Figure 219).
Compression Test Procedures
1.
Install the compression gauge into the spark plug
hole. IMPORTANT: Be certain that no more than
1/2” of the gauge is threaded into the cylinder as
damage to the piston may result.
2.
3.
Pull the starter rope several times to obtain the
highest compression reading.
If the compression reading is below 100 psi (689
kPa), cylinder, piston, or ring damage should be
suspected. If so damaged, a new engine short
block should be installed.
ENGINE REMOVAL
Figure 219
0406-036
1.
2.
Completely drain all fuel from the fuel tank.
6.
Thread the knot at the end of the recoil starter
rope through the side of the rope handle and untie
the knot.
Remove upper shroud (Figure 218). Refer to
"Removing The Upper Shroud" on page 9 - 4.
7.
8.
Remove the choke linkage, fuel line, and primer
hose from the carburetor.
Disconnect the lead wires from the On/Off switch.
Figure 218
0406-035
3.
4.
Place the fuel tank cap back on the fuel tank.
Disconnect the spark plug high tension wire.
9 - 16
Single Stage Snowthrower Service Manual
(3 votes, average: 4.67 out of 5) Lawn and Garden readers have rated Toro Single Stage Snow Blower Service Manual 4.7 out of 5.0 based on 3 product reviews.
EXCELLENT . Hard to find manual and very detailed . Only downside is the pics and wording in pics are backwards , but I can deal with that
The manual provides detailed step-by-step instructions for engine removal and installation but there is nothing in it about repair of the recoil starter. The engine removal instructions will be helpful because the starter is buried behind the fuel tank and engine support bracket. I think my problem is a sticking starter dog but getting to it will be a major project.
manual downloak for toro snwo thorower, downlod manual for toro