ENGINE REMOVAL AND INSTALLATION
B. Install the crankshaft pulley. Refer to
"Crankshaft Pulley Replacement" on page 5 -
3.
3.
Remove the belt from the engine pulley and
remove the engine pulley and key if so equipped
(Figure 47).
C. Connect the spark plug lead wire.
D. Install the belt and side plate. Refer to
"Replacing Drive Belt" on page 5 - 1.
Complete Steps 5 through 7.
Chain Drive Units:
A. Install the crankshaft sprocket. Be certain to
align the keyway (slot) of the crankshaft
sprocket with the location key on the
crankshaft. Should the locating key on the
crankshaft show signs of wear, replace.
B. Install the chain. Refer to "Chain
Replacement" on page 5 - 25. Do Step 3.
Align and adjust the chain. Refer to
"Crankshaft Sprocket Replacement (all
models)" on page 5 - 21. Consult Steps 5
through 8.
Figure 47
1854-35-2
4.
Remove the two screws at the bottom of the
control panel and remove the control panel cover
(Figure 48).
C. Install left side plate and chainguard.
D. Connect the spark plug lead wire.
POWERLITE, ENGINE REMOVAL
1.
Use a pump type siphon to remove the fuel from
the fuel tank.
2.
Remove the belt cover from the left side (Figure
46).
A
Figure 48
1854-42
(A) Screws
Figure 46
1854-35
Single Stage Snowthrower Service Manual
4 - 5
(3 votes, average: 4.67 out of 5) Lawn and Garden readers have rated Toro Single Stage Snow Blower Service Manual 4.7 out of 5.0 based on 3 product reviews.
EXCELLENT . Hard to find manual and very detailed . Only downside is the pics and wording in pics are backwards , but I can deal with that
The manual provides detailed step-by-step instructions for engine removal and installation but there is nothing in it about repair of the recoil starter. The engine removal instructions will be helpful because the starter is buried behind the fuel tank and engine support bracket. I think my problem is a sticking starter dog but getting to it will be a major project.
manual downloak for toro snwo thorower, downlod manual for toro