GAS POWER SHOVEL
REPLACE SCRAPER
STORAGE
The scraper blade located on the bottom of the Power
Shovel should be replaced if worn.
1.
Refer to "Draining The Fuel Tank" on page 9 - 4.
Complete all steps on page 9 - 4.
1.
2.
3.
Remove the rotor; refer to "PADDLE
REPLACEMENT - STRAIGHT PADDLE" on page
7 - 2).
2.
3.
Remove the spark plug.
Next, pour two teaspoons of engine oil into the
spark plug hole.
Remove the three screws, six washers, and three
locknuts used to hold the scraper blade (Figure
240).
4.
Pull the recoil starter slowly to distribute oil on the
inside of the cylinder.
Attach the new scraper blade taking care to hook
scraper over front edge of the housing. Secure
with existing screws, washers and locknuts, and
tighten.
5.
6.
Replace the spark plug.
Clean the rotor, rotor housing, and exterior of
Power Shovel. Tighten all screws and nuts. If any
part is damaged, repair or replace it.
7.
Store the Power Shovel in a clean dry place and
cover the unit to give it protection. Never store the
unit in the house or basement.
Figure 240
0406-057
Single Stage Snowthrower Service Manual
9 - 23
(3 votes, average: 4.67 out of 5) Lawn and Garden readers have rated Toro Single Stage Snow Blower Service Manual 4.7 out of 5.0 based on 3 product reviews.
EXCELLENT . Hard to find manual and very detailed . Only downside is the pics and wording in pics are backwards , but I can deal with that
The manual provides detailed step-by-step instructions for engine removal and installation but there is nothing in it about repair of the recoil starter. The engine removal instructions will be helpful because the starter is buried behind the fuel tank and engine support bracket. I think my problem is a sticking starter dog but getting to it will be a major project.
manual downloak for toro snwo thorower, downlod manual for toro