GAS POWER SHOVEL
9.
The engine is mounted on a single engine mount
and is supported with a rubber isolator mount. To
disconnect the engine from the housing, remove
the screw and nut which hold the engine mount to
the housing (Figure 220).
ENGINE SHORT BLOCK
If engine compression falls below 100 psi, or if internal
damage to the cylinder has occurred, the engine short
block must be replaced. An engine short block is
available as a factory sealed assembly only. Individual
replacement short block parts (such as a piston, piston
ring, crankshaft, cylinder, and crankcase) are not
available.
To Replace An Engine Short Block
1.
2.
Remove the engine from the snowthrower frame
(Refer to "ENGINE REMOVAL" on page 9 - 16).
Remove the carburetor and stress plate screws.
Scrape excess gasket material away from the
carburetor body with a putty knife or a wooden
dowel (Figure 222).
Figure 220
0406-037
10.
Remove the rubber drive coupling from the
crankshaft adaptor and remove the engine from
the housing (Figure 221).
Figure 222
0406-039
Figure 221
0406-038
Single Stage Snowthrower Service Manual
9 - 17
(3 votes, average: 4.67 out of 5)
Lawn and Garden readers have rated Toro Single Stage Snow Blower Service Manual 4.7 out of 5.0 based on 3 product reviews. EXCELLENT . Hard to find manual and very detailed . Only downside is the pics and wording in pics are backwards , but I can deal with that
The manual provides detailed step-by-step instructions for engine removal and installation but there is nothing in it about repair of the recoil starter. The engine removal instructions will be helpful because the starter is buried behind the fuel tank and engine support bracket. I think my problem is a sticking starter dog but getting to it will be a major project.
manual downloak for toro snwo thorower, downlod manual for toro