GAS POWER SHOVEL
3.
Remove the muffler and dried gasket material and
carbon build up with a putty knife or wooden dowel
(Figure 223).
5.
Remove the cooling shroud (Figure 225).
Figure 225
0406-042
6.
Remove the ignition module. Inspect the module
and wire insulation for damage. Replace as
needed (Figure 226).
Figure 223
0406-040
4.
Remove the recoil starter assembly. Check the
condition of the starter rope. If the rope is worn,
replace it with #4 Diamond Braid Rope (Figure
224).
Figure 226
0406-043
7.
8.
Remove the flywheel (Refer to "FLYWHEEL
REMOVAL" on page 9 - 19).
Remove the backing plate. NOTE: When
reinstalling the backing plate, replace the intake
gasket with a new gasket. To ensure that the
intake gasket, backing plate, and cylinder intake
port are in proper alignment and that the gasket is
sealing properly, install the stress plate and
tighten the intake screws at 20 - 30 inĀ·lbs. prior to
tightening the backing plate screws.
Figure 224
0406-041
9 - 18
Single Stage Snowthrower Service Manual
(3 votes, average: 4.67 out of 5) Lawn and Garden readers have rated Toro Single Stage Snow Blower Service Manual 4.7 out of 5.0 based on 3 product reviews.
EXCELLENT . Hard to find manual and very detailed . Only downside is the pics and wording in pics are backwards , but I can deal with that
The manual provides detailed step-by-step instructions for engine removal and installation but there is nothing in it about repair of the recoil starter. The engine removal instructions will be helpful because the starter is buried behind the fuel tank and engine support bracket. I think my problem is a sticking starter dog but getting to it will be a major project.
manual downloak for toro snwo thorower, downlod manual for toro