DRIVE SYSTEMS
Chain Adjustment Procedure (all models)
5.
Loosen one bolt on the starter housing located on
the right side of the engine (Figure 106).
Proper chain adjustment is critical to all 14” and 21”
single stage snowthrowers. If the chain is too slack or
misaligned, the teeth of the impeller sprocket can
shear. Also, if the chain is loose, the stripper assembly
can break. If the chain is too tight, the drive system
can bind, or potentially, break the crankshaft. When
properly adjusted, the chain should be snug, with not
more than 1/8 inch deflection or slack. If an adjustment
is necessary, proceed with the following:
1.
Drain the fuel from the fuel tank. Refer to
"Draining The Fuel Tank" on page 2 - 5. Complete
step 1.
2.
3.
Remove the chain guard from the left side of the
unit.
Figure 106
0217-057
6.
Pull the engine back until the chain is snug, with
no more than 1/8 inch deflection or slack (Figure
107).
Remove the upper and lower shrouds by
removing the fuel cap and mounting screws. After
removing the shrouding, reinstall the fuel cap.
Disconnect the spark plug lead wire.
4.
Loosen the four engine mounting nuts on the left
side of the engine (Figure 105).
Figure 105
0217-056
Figure 107
0217-058
5 - 20
Single Stage Snowthrower Service Manual
(3 votes, average: 4.67 out of 5) Lawn and Garden readers have rated Toro Single Stage Snow Blower Service Manual 4.7 out of 5.0 based on 3 product reviews.
EXCELLENT . Hard to find manual and very detailed . Only downside is the pics and wording in pics are backwards , but I can deal with that
The manual provides detailed step-by-step instructions for engine removal and installation but there is nothing in it about repair of the recoil starter. The engine removal instructions will be helpful because the starter is buried behind the fuel tank and engine support bracket. I think my problem is a sticking starter dog but getting to it will be a major project.
manual downloak for toro snwo thorower, downlod manual for toro