DRIVE SYSTEMS
5.
When installing the replacement belt, loop the belt
around the engine pulley and under the idler
pulley. Now start the belt around the impeller
pulley (Figure 60).
7.
Finally, install the drive cover with the washer-
faced cap screw, four screws, and locknuts.
Belt Alignment
Whenever a pulley is removed, or if belt jumping is
experienced, belt alignment will be necessary. To align
the crankshaft pulley and rotor pulley perform the
following procedures. They are:
1.
2.
Refer to "Replacing Drive Belt" on page 5 - 1.
Complete steps 1 and 2.
Loosen the two allen head screws on the
crankshaft pulley (Figure 62).
Figure 60
0217-032
6.
After the belt is started around the impeller pulley,
pull the idler up and rotate the impeller pulley
forward allowing the belt to roll on (Figure 61).
Figure 62
0217-034
Figure 61
0217-033
5 - 2
Single Stage Snowthrower Service Manual
(3 votes, average: 4.67 out of 5)
Lawn and Garden readers have rated Toro Single Stage Snow Blower Service Manual 4.7 out of 5.0 based on 3 product reviews. EXCELLENT . Hard to find manual and very detailed . Only downside is the pics and wording in pics are backwards , but I can deal with that
The manual provides detailed step-by-step instructions for engine removal and installation but there is nothing in it about repair of the recoil starter. The engine removal instructions will be helpful because the starter is buried behind the fuel tank and engine support bracket. I think my problem is a sticking starter dog but getting to it will be a major project.
manual downloak for toro snwo thorower, downlod manual for toro