DRIVE SYSTEMS
3.
Align the crankshaft pulley and rotor pulley with a
straight edge (ie. ruler, piece of wood, etc...)
(Figure 63).
Crankshaft Pulley Replacement
1.
2.
3.
Refer to "Replacing Drive Belt" on page 5 - 1.
Complete steps 1 through 4.
Loosen the two allen head screws on crankshaft
pulley. Slide pulley off crankshaft (Figure 62).
Slide replacement crankshaft pulley on the
crankshaft. Be certain to align the keyway (slot) in
the crankshaft pulley with the location key on the
crankshaft. Should the location key on the
crankshaft show signs of wear, replace (Figure
64).
Figure 63
0217-035
4.
When both pulleys are aligned with respect to the
straight edge, tighten the allen head screws on the
crankshaft pulley.
5.
6.
If the idler pulley is not centered with respect to
the V-belt, adjust by bending the idler arm.
Refer to "Replacing Drive Belt" on page 5 - 1.
Complete step 7.
Figure 64
0217-036
4.
5.
Refer to "Belt Alignment" on page 5 - 2 (Figure
63). Perform steps 3 through 5.
Refer to "Replacing Drive Belt" on page 5 - 1.
Complete steps 5 through 7.
Single Stage Snowthrower Service Manual
5 - 3
(3 votes, average: 4.67 out of 5) Lawn and Garden readers have rated Toro Single Stage Snow Blower Service Manual 4.7 out of 5.0 based on 3 product reviews.
EXCELLENT . Hard to find manual and very detailed . Only downside is the pics and wording in pics are backwards , but I can deal with that
The manual provides detailed step-by-step instructions for engine removal and installation but there is nothing in it about repair of the recoil starter. The engine removal instructions will be helpful because the starter is buried behind the fuel tank and engine support bracket. I think my problem is a sticking starter dog but getting to it will be a major project.
manual downloak for toro snwo thorower, downlod manual for toro