GAS POWER SHOVEL
FLYWHEEL REMOVAL
7.
Alternate tightening the 1/4 - 20 x 2 inch screws
into the cored holes until the seat between the
crankshaft and the flywheel is loosened (Figure
229).
1.
Remove the engine (Refer to "ENGINE
REMOVAL" on page 9 - 16).
2.
3.
4.
Remove the cooling shroud.
Remove the recoil starter assembly.
Anchor the starter cup with Toro Multi-Purpose
Tool #45-1390 and remove the flywheel nut with a
3/4” open end wrench (Figure 227).
Figure 229
0406-046
IGNITION TIMING/GOVERNOR
The Toro Gas Power Shovel is equipped with a speed
limiting capacitator discharge ignition (C.D.I.) module.
The C.D.I. module electronically performs the functions
of coil, points, and condenser as well as governing the
engine speed.
Figure 227
0406-044
5.
Tap the 2 cored flywheel holes with a 1/4 - 20 tap
(Figure 228).
To Properly Time the Engine:
1.
2.
3.
4.
Remove the engine from the snowthrower frame.
Remove the carburetor.
Remove the cooling shroud.
Loosen the C.D.I. module mounting screws.
Figure 228
0406-045
6.
Install the Toro Multi-Purpose Tool with two 1/4 -
20 x 2 inch screws so that the flat portion of the
tool is in contact with the end of the crankshaft.
Single Stage Snowthrower Service Manual
9 - 19
(3 votes, average: 4.67 out of 5)
Lawn and Garden readers have rated Toro Single Stage Snow Blower Service Manual 4.7 out of 5.0 based on 3 product reviews. EXCELLENT . Hard to find manual and very detailed . Only downside is the pics and wording in pics are backwards , but I can deal with that
The manual provides detailed step-by-step instructions for engine removal and installation but there is nothing in it about repair of the recoil starter. The engine removal instructions will be helpful because the starter is buried behind the fuel tank and engine support bracket. I think my problem is a sticking starter dog but getting to it will be a major project.
manual downloak for toro snwo thorower, downlod manual for toro