DRIVE SYSTEMS
End Cap/Shaft And Bearing Replacement For 1980
S-200’s
4.
R. H. (right hand) end cap/bushing and shaft
servicing:
1.
2.
3.
Refer to "Replacing Drive Belt" on page 5 - 1.
Complete steps 1 through 4.
A. Slide the end cap/bushing assembly off the
shaft (Figure 74). Should the bushing surface
appear to be “wallowed” out (oval shaped),
replace both the end cap/bushing assembly
and the shaft mounted in the R. H. (right hand)
side plate.
Refer to "Rotor Pulley Replacement" on page 5 -
6. Complete step 2 only.
Remove all screws retaining the rotor paddles to
the rotor halves. Also, remove the four self-
tapping rotor screws, which locate the rotor halves
in the correct position around the end cap
assemblies (Figure 73). (Note: Earlier models
may not have rotor location screws.) Remove
rotor halves and paddles.
Figure 74
0217-046
5.
L. H. (left hand) end cap/shaft and bearing
servicing:
A. Remove the thin washer and spacer on the
shaft.
Figure 73
0217-045
Single Stage Snowthrower Service Manual
5 - 7
(3 votes, average: 4.67 out of 5) Lawn and Garden readers have rated Toro Single Stage Snow Blower Service Manual 4.7 out of 5.0 based on 3 product reviews.
EXCELLENT . Hard to find manual and very detailed . Only downside is the pics and wording in pics are backwards , but I can deal with that
The manual provides detailed step-by-step instructions for engine removal and installation but there is nothing in it about repair of the recoil starter. The engine removal instructions will be helpful because the starter is buried behind the fuel tank and engine support bracket. I think my problem is a sticking starter dog but getting to it will be a major project.
manual downloak for toro snwo thorower, downlod manual for toro