DRIVE SYSTEMS
3.
Using a 5/8” open end wrench and a 1/2” socket
wrench, remove the shoulder bolt, washers, and
nut, retaining the idler assembly to the left side
plate (Figure 67). At this point, inspect the entire
assembly. If the idler arm is misformed, replace.
Also, inspect the washers for excessive wear.
Replace if necessary.
5.
Reassemble the idler assembly and attach it to
the left side plate with shoulder bolt, washers, and
nut (Figure 69). Tighten the nut firmly.
Figure 69
0217-041
Figure 67
0217-039
6.
7.
Attach idler spring. Refer to "Idler Spring
Replacement" on page 5 - 4. Complete step 3.
4.
By removing the capscrew and locknut that retains
the idler pulley to the idler arm, the idler pulley can
be removed and the bearings can be inspected
(Figure 68). Should the bearing have unusual
side to side play or be “wallowed” (oval shaped),
replace the idler pulley and the capscrew.
Attach belt. Refer to "Replacing Drive Belt" on
page 5 - 1. Complete steps 5 through 7. Replace
the upper shroud.
Figure 68
0217-040
Single Stage Snowthrower Service Manual
5 - 5
(3 votes, average: 4.67 out of 5) Lawn and Garden readers have rated Toro Single Stage Snow Blower Service Manual 4.7 out of 5.0 based on 3 product reviews.
EXCELLENT . Hard to find manual and very detailed . Only downside is the pics and wording in pics are backwards , but I can deal with that
The manual provides detailed step-by-step instructions for engine removal and installation but there is nothing in it about repair of the recoil starter. The engine removal instructions will be helpful because the starter is buried behind the fuel tank and engine support bracket. I think my problem is a sticking starter dog but getting to it will be a major project.
manual downloak for toro snwo thorower, downlod manual for toro