ENGINE REMOVAL AND INSTALLATION
8.
Pull the recoil starter rope through the hole in the
control panel (Figure 42). Next, slide the rope
onto and through the starter handle and make a
small knot. Slide the starter rope back into the
starter handle. Remove the knot in the starter
rope at the starter housing and allow the starter
rope to retract into the starter.
10. If your snowthrower is equipped with an electric
starter, install the starter to the engine mounting
bracket (Figure 44). Torque the starter mounting
bolts at the mounting bracket to 120 - 180 in·lbs.
Install the wire harness with the cable clamp to the
engine. Replace the starter motor tie down strap.
Finally, mount the switch and plug assembly to the
lower shroud.
Figure 42
0217-025
9.
On 20” models, slide the muffler into place on the
engine. Torque the muffler nuts to 90 - 120 in·lbs.
(Figure 43).
Figure 44
0217-027
Note: Do not over torque the nuts, you may crack
the engine block.
11. Belt Drive Units:
A. Torque the crankshaft engine mounting nut to
170 - 220 in·lbs. Then tighten the starter nut to
70 - 120 in·lbs (Figure 45).
Figure 43
0217-026
Figure 45
0217-028
4 - 4
Single Stage Snowthrower Service Manual
(3 votes, average: 4.67 out of 5) Lawn and Garden readers have rated Toro Single Stage Snow Blower Service Manual 4.7 out of 5.0 based on 3 product reviews.
EXCELLENT . Hard to find manual and very detailed . Only downside is the pics and wording in pics are backwards , but I can deal with that
The manual provides detailed step-by-step instructions for engine removal and installation but there is nothing in it about repair of the recoil starter. The engine removal instructions will be helpful because the starter is buried behind the fuel tank and engine support bracket. I think my problem is a sticking starter dog but getting to it will be a major project.
manual downloak for toro snwo thorower, downlod manual for toro