Toro 08161SL Service Manual Model 30412 Groundsmaster 4000 D Preface Publication

Procedure  for  Lift/Lower  Circuit Relief  Pressure
Test
NOTE:  Before attempting to check or  adjust lift pres-
sure, make sure  that counterbalance pressure is  cor-
rectly adjusted.
3
1.
perature by operating the machine for approximately 10
minutes. Make sure the hydraulic tank is full.
Make sure hydraulic oil is at normal operating tem-
2.
decks lowered and off. Make sure engine is off and the
parking brake is applied.
Park machine  on  a level  surface with  the cutting
4
2
1
CAUTION
Figure 41
Prevent personal injury and/or damage to equip-
ment. Read all WARNINGS, CAUTIONS and Pre-
cautions for Hydraulic Testing at the  beginning
of this section.
1.
2.
Fan drive manifold
Lift circuit test port
3.
4.
Lift control valve
Relief valve
2
3
3.
Raise seat to gain access to lift circuit test port at the
fan drive manifold (Fig. 41). Connect a 5,000 PSI (345
bar) gauge  with hydraulic hose  attached to test  port.
Route gauge hose to allow seat to be safely lowered.
4
5
4.
Sit on the seat and start the engine. Move throttle to
full speed (2870 RPM).
5.
the cutting decks. Momentarily hold the lever with the lift
cylinder at full extension while looking at the gauge.
While sitting on the seat, pull lift lever back to raise
1
GAUGE READING TO BE 1500 to 1600 PSI (104 to
110
bar).
6.
7.
Stop the engine and record test results.
If pressure is too high, adjust relief valve in lift control
Figure 42
valve by rotating counterclockwise (Figure 42). If pres-
sure is too low, check for restriction in pump intake line.
Check the lift cylinder for internal leakage. If cylinder is
not leaking, adjust the relief valve by rotating clockwise.
Repeat steps 4 through 6 after making a relief valve ad-
justment. If pressure is  still too low, pump or  lift cylin-
der(s)  should   be  suspected   of  wear,   damage  or
inefficiency.
1.
2.
3.
Control valve assembly
Relief valve assembly
Washers
4.
5.
Spring
Poppet
8.
When  testing  is completed,  disconnect  pressure
gauge from test port.
Groundsmaster 4000--D
Page 4 -- 53
Hydraulic System
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 298 pages
Document TypeCatalog
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website