Toro 08161SL Service Manual Model 30412 Groundsmaster 4000 D Preface Publication

Flush Hydraulic System
IMPORTANT: Flush the hydraulic  system any time
there is a severe component failure or the system is
contaminated (oil appears milky, black or contains
metal particles).
9.  Turn ignition key switch and  engage starter for ten
(10) seconds  to prime  hydraulic pumps.  Repeat this
step again.
10.Connect
electrical connector to engine run solenoid.
1.
decks to  the ground,  stop engine  and apply  parking
brake. Remove key from the ignition switch.
Park  machine  on a  level  surface.  Lower  cutting
11.
Start engine and let it idle at low speed (1450 RPM)
for  a minimum  of  two (2)  minutes.  Increase engine
speed to high idle (2870 RPM) for minimum of one (1)
minute under no load.
CAUTION
12.Raise
and lower cutting  decks several times. Turn
steering wheel fully left and right several times.
Operate all hydraulic controls to relieve system
pressure and avoid injury from pressurized hy-
draulic oil.
13.Shut
Check oil level  in hydraulic reservoir  and add correct
amount of oil if necessary.
off engine  and check  for hydraulic oil  leaks.
IMPORTANT: Make  sure to  clean  around any  hy-
draulic connections  that will be  disconnected for
draining.
14.Operate
erating conditions.
machine for two (2) hours under normal op-
15.Check
shows  any  signs  of  contamination,  repeat  steps  1
through 14 again until oil is clean.
condition  of hydraulic  oil.  If the  new  fluid
2.
3.
Drain hydraulic reservoir.
Drain hydraulic system. Drain all hoses,  tubes and
components while the system is warm.
16.Assume
normal operation and follow recommended
maintenance intervals.
4.
5.
Change and replace both hydraulic oil filters.
Inspect and clean hydraulic reservoir (see Hydraulic
Reservoir Inspection in this section).
6.
that were disconnected while draining system.
Connect all hydraulic hoses, lines and components
NOTE:  Useonly hydraulic fluids specifiedintheOpera-
tor’s Manual. Other fluids may cause system damage.
7.
8.
Fill hydraulic reservoir with new hydraulic fluid.
Disconnect electrical connector from engine run so-
lenoid.
Hydraulic System
Page 4 -- 62
Groundsmaster 4000--D
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 298 pages
Document TypeCatalog
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website