Installation (Fig. 13)
Place spindle plate on cutting deck making sure to
1.
align notches in plate and cutting deck.
2.
making sure that grease fitting is toward the front of the
deck.
Positionspindle housingtoundersideofcuttingdeck
3.
deck with six (6) cap screws and flange nuts.
Secure spindle housing and spindle plate to cutting
2
2
1
4.
Install cutting blade, anti--scalp cup and bolt (see
CuttingUnitOperator’s Manual).Tightenbladeboltfrom
88
5.
to 108 ft--lb (119 to 146 N--m).
Position O--ring to top of spindle housing.
Figure 14
1.
Hydraulic deck motor
2.
Socket head screw
6.
Positionhydraulic deckmotortocutting deckmaking
sure to align motor shaft splines with spindle shaft
splines.
7.
two (2) socket head screws and flat washers.
Secure hydraulic deck motor to the cutting unit with
IMPORTANT: When greasing spindles on the
Groundsmaster 3505--D, grease passes into the
center of the spindle shaft and out to fill the bearing
cavity of the housing. If grease does not come out
of lower seal when greasing, check lubrication hole
in spindle shaft for obstruction.
NOTE: Pneumatic grease guns can produce air pock-
ets when filling large cavities. Use a hand pump grease
gun when adding grease to spindle housing.
8.
cavity with grease until grease starts to come out of low-
er seal.
Using a hand pump grease gun, fill spindle housing
Groundsmaster 3505--D
Page 7 -- 13 Rev. A
Cutting Units
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Groundsmaster 3505 D |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)