4.
grease on lips of seals.
Pack the bearing cones with grease. Apply a film of
PRESS
4
7
5.
Install lower bearing and seal into bottom of spindle
housing. Note: The bottom seal must have the lip facing
out (down) (Fig. 18).
6.
Slide spacer ring and inside spacer into spindle
3
2
housing, then install upper bearing and seal into top of
housing. Note: The upper seal must have the lip facing
out (up) (Fig. 18).
1
6
5
7.
Inspect the spindle shaft to make sure it is free of
burrs or nicks that could possibly damage the seals.
Also, make sure that lubrication hole in shaft is clean.
Lubricate the shaft with grease.
Figure 17
1.
2.
3.
4.
Bearing cups
Large snap ring
Large spacer
Arbor press
5.
6.
7.
Support
Arbor press base
Spindle housing
8.
Install spindle spacer onto shaft. Carefully slide
spindle shaft through spindle housing. The bottom seal
and spindle spacer will fit together when the spindle is
installed fully.
2
9.
130
Thread spindle nut onto shaft and tighten nut from
to 160 ft--lb (176 to 216 N--m).
1
Figure 18
1.
Bottom seal installation
2.
Upper seal installation
Groundsmaster 3505--D
Page 7 -- 15 Rev. A
Cutting Units
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Groundsmaster 3505 D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)