Toro 05145SL Rev B Groundsmaster 3505 D Service Manual

Procedure for Wheel Motor Efficiency Test:
Make sure hydraulic oil is at normal operating tem-
12.Motor internal leakage will be shown on flow meter
in GPM.  Flow should  be less  than 1.5 GPM  for the
tested wheel motor.
1.
perature. Make sure the hydraulic tank is full.
13.If
needs to be repaired or replaced as necessary.
specifications are not met, the tested wheel motor
2.
lowered and off. Make sure engine is off and the parking
brake is engaged.
Parkmachineonalevelsurfacewiththecuttingunits
14.If remaining front wheel motor requires testing, com-
plete steps 5 to 14 for the remaining motor.
3.
4.
tral position (see Adjust Traction Drive for Neutral in the
Adjustments Section).
Read Precautions for Hydraulic Testing.
15.Relieve
hydraulic system  pressure (See Relieving
Make sure that traction pedal is adjusted to the neu-
Hydraulic System Pressure in the General Information
section). Disconnect  tester  from hydraulic  fitting and
hose. Reconnect hose to pump connection.
5.
and an immovable object to prevent the machine from
moving during testing.
Attachaheavychaintotherearofthemachineframe
6.
the wheel. Make sure parking brake is on.
Chock front wheel being tested to prevent rotation of
2
WARNING
Before disconnecting or performing any work
on the  hydraulic system,  all pressure  in the
system must  be relieved.  See  Relieving Hy-
draulic System Pressure in the General Infor-
mation section.
1
Figure 19
1.
Lower hydraulic fitting
2.
Piston pump
7.
Disconnect hydraulic  lines from front  wheel motor
that is  not being tested.  Cap disconnected  hydraulic
lines and plug ports in wheel motor to prevent contami-
nation.
8.
Disconnect hose from the lower hydraulic fitting on
the bottom of the hydrostat (Fig. 19).
NOTE:  An alternate testing location would be at the hy-
draulic hose connection to the hydraulic tube under the
left floor plate.
9.
with the pump and the disconnected hose. Make  sure
the tester flow control valve is fully open.
Install hydraulic tester (pressure and flow) in series
10.Start
engine and move throttle to full speed (3050 +
50
RPM).
CAUTION
Use extreme caution when performing test. The
front tire on the ground will be trying to move the
machine forward.
11.
1000
Slowly push traction pedal in forward direction until
PSI is displayed on the tester pressure gauge.
Groundsmaster 3505--D                                        Page 4 -- 33
Hydraulic System
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 210 pages
Document TypeService Manual
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website