Removal (Fig. 14)
Park machine on a level surface, lower attachment,
stop engine, apply parking brake and remove key from
ignition switch.
Installation (Fig. 14)
1.
1. If bearing cups were removed from frame, press new
bearing cups into frame making sure that cups are
pressed fully to the shoulder in the frame.
2.
Remove fuel tank from machine (see Fuel Tank Re-
2. Pack bearing cones with grease.
moval in the Service and Repairs section of Chapter 3
3.
lower bearing cone onto fork shaft.
Slide bearing spacer onto castor fork shaft. Press
–
Engine).
3.
this section).
Remove front wheel (see Front Wheel Removal in
4.
Raise castor fork up through frame. Place upper
bearing cone and flat washer on castor fork shaft.
Thread slotted hex nut onto fork shaft but do not fully
tighten.
4.
tion hydraulic hoses away from fork taking care to not
damage hydraulic lines.
Remove hose guide from castor fork. Carefully posi-
5.
Set the fork bearings by tightening the slotted hex nut
5.
this section).
Remove steering box (see Steering Box Removal in
from 75 to 100 in-lb (8.5 to 11.3 N–m) while rotating the
castor fork by hand. Then, loosen the nut until the fork
has endplay.
6.
Remove castor fork from machine:
6.
(1.7
Next, tighten the slotted hex nut from 15 to 20 in-lb
to 2.3 N–m) while rotating the fork by hand. After fi-
A. Support castor fork to prevent it from falling.
nal tightening, make sure that the fork does not have any
endplay and it rotates without binding.
B. Remove cotter pin and slotted hex nut that secure
castor fork to frame.
7.
Secure slotted hex nut to castor fork with cotter pin.
C. Lower castor fork from machine.
8.
this section).
Install steering box (see Steering Box Installation in
D. Locate and retrieve flat washer (item 18).
Remove bearing cones and bearing spacer.
Clean and inspect bearing cups and cones. If wear
7.
8.
9.
this section).
Install front wheel (see Front Wheel Installation in
or damage is identified, replace bearings.
10.Carefully
hose guide.
position hydraulic hoses to fork and install
9.
If necessary, remove bearing cups from machine
frame.
11.
Install fuel tank to machine (see Fuel Tank Installa-
tion in the Service and Repairs section of Chapter 3 –
Engine).
Sand Pro & Infield Pro 3040/5040
Page 6 – 23
Chassis
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro 3040, Toro 5040 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)