5.
as needed using Figure 43 as a guide.
Disassemble remaining pump control components
B. Start engine and depress traction pedal fully in
the reverse direction. Using a phototac, check that
rear wheel speed is from 135 to 180 RPM.
Assembly (Fig. 43)
C. If necessary, adjust ball joint on traction rod to
provide rear wheel speed from 135 to 180 RPM.
1.
ing Figure 43 as a guide.
Assemble pump control components as needed us-
D. With engine stopped, depress traction pedal fully
in the forward direction and check that pump lever is
rotated fully. Also check that clearance between ped-
al hub and pedal stop is from 0 to .120” (3 mm). Ad-
just stop if necessary (see Operator’s Manual).
CAUTION
The extension spring is under tension and may
cause personal injury during installation. Use
caution when installing spring to the pump arm.
9.
Position center shroud to machine and secure with
two (2) cap screws and flat washers (Fig. 46).
2.
en lock nut on adjustment pin to allow from .475” to .725”
Attach extension spring to anchor point of arm. Tight-
(12.1
to 18.4 mm) thread length to extend beyond the
1
lock nut (Fig. 44).
3.
If ball joint was removed from traction rod, install ball
2
joint so that distance from center of ball joint stud to cen-
ter of bearing is from 14.050” to 14.170” (35.7 to 36.0
cm) (Fig. 45).
4
3
4.
Secure traction rod to pump lever with cap screw, flat
washer and lock nut.
Figure 44
3.
4.
5.
plugged into machine wire harness.
Make sure that traction neutral switch connector is
1.
2.
Extension spring
Lock nut
Adjustment pin
Thread extension
6.
Check and adjust neutral position (see Operator’s
Manual).
7.
Check and adjust traction neutral switch (see Opera-
tors Manual).
8.
Check traction rod adjustment as follows:
14.050”
to 14.170”
WARNING
(35.7 to 36.0 cm)
Figure 45
Before raising the machine, review and follow
Jacking Instructions in Chapter 1 – Safety.
2
3
A. Raise machine so front wheel and one rear wheel
are off the ground and can rotate freely. Support ma-
chine with jackstands or wooden blocking. Chock the
rear wheel on the ground to prevent it from rotating.
1
CAUTION
Use extreme caution because the rear wheel on
the ground will be trying to move the machine
rearward.
Figure 46
3.
1.
2.
Center shroud
Cap screw (2 used)
Flat washer (2 used)
Sand Pro & Infield Pro 3040/5040
Page 4 – 53
Hydraulic System
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro 3040, Toro 5040 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)