Toro 10177SL Models 30449 30447 Groundsmaster 4100 4110 D Service Manual

IMPORTANT: Use   caution  when   clamping   gear
pump in a vise to avoid distorting any pump compo-
nents.
NOTE:  Pressure  seals  and  back--up  gaskets  fit  in
grooves machined into  thrust plates. Body seals  fit in
grooves machined in body faces.
3.
drive shaft pointing down.
Secure the front cover of the pump in a vise with the
2.  Assemble pump sections starting at front cover end.
Apply grease or petroleum jelly to new section seals to
hold them in position during gear pump assembly.
4.
Loosen the four (4) cap screws thatsecure pump as-
sembly.
3.  After pump has been assembled, tighten capscrews
byhand.Rotate  thedrive shafttocheck  for binding.Pro-
tect the shaft if using a pliers to rotate shaft.
5.
Remove pump from vise and remove cap screws.
6.
Supportthepumpassemblyandgentlytapthepump
4.
pattern to a torque of 33 ft--lb (45 N--m).
Tighten the four (4) cap screws evenly in a crossing
case with a soft face hammer to loosen the pump sec-
tions. Be careful  to not drop  parts or disengage  gear
mesh.
IMPORTANT: Mark the relative positions of the gear
teeth and the thrust plates so they can be reassem-
bledinthesameposition.Donottouchthegearsur-
faces as residue on hands may be corrosive to gear
finish.
1
2
3
7.
Remove the thrust plates and seals from each pump
4
section. Before removing each gear set, apply marking
dye to mating teeth to retain  ”timing”. Pump efficiency
may be affected if the teeth are not installed in the same
position during assembly. Keep the parts for each pump
section together; do not mix parts between sections.
8.
Clean  all parts.  Check  all components  for  burrs,
scoring, nicks and other damage.
9.
Replace the entire pump assembly  if parts are ex-
cessively worn or scored.
Figure 60
Assembly (Fig. 58)
1.
2.
3.
4.
LH and RH PTO pump section
Front PTO pump section
Steering, lift/lower and charge pump section
Engine cooling fan pump section
1.
Apply clean hydraulic oil to all parts before assem-
bling.
Groundsmaster 4100--D/4110--D
Page 4 -- 85
Hydraulic System
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags, , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 340 pages
Document TypeService Manual
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website