Toro 10177SL Models 30449 30447 Groundsmaster 4100 4110 D Service Manual

4.
Turn the ignition switch to the ON position, but do not
start machine.
TEC--5002
MASTER
OVERLAY
NOTE:  The red text on the Diagnostic Display overlay
decal refers to input switches and the green text refers
to TEC outputs.
5.
Make sure that the “INPUTS DISPLAYED” LED, on
lower right column of  the Diagnostic Display, is illumi-
nated. If “OUTPUTS DISPLAYED” LED is  illuminated,
press the  toggle button  on the Diagnostic  Display to
change to “INPUTS DISPLAYED” LED.
6.
The  Diagnostic  Display   will  illuminate  the  LED
associatedwitheachoftheinputswhenthatinputswitch
is closed. Individually,change each oftheswitches from
open to closed  (i.e., sit on  seat, press traction pedal,
etc.), and notethattheappropriate  LEDon theDiagnos-
ticDisplaywillilluminatewhenthecorresponding    switch
is closed. Repeat on each switch that is possible to be
changed by hand (see Inputs and LED Operation chart
on following page).
NOTE:  When the Diagnostic Display is attached to the
wire harness connector and the ignition switch is in the
ON position, the input LED for hydraulic temp and cool-
anttempshouldbeilluminated.   Iftheharnessconnector
is disconnected from the sensor for  either of these in-
puts, the appropriate LED should go off after a few sec-
ond delay. Then, if the harness connector is reattached
tothesensor,theinputLEDshouldagainilluminateafter
a few seconds.
Figure 9
TEC--5001
SLAVE
OVERLAY
7.
If appropriate LED does not toggle on and off when
switch state is changed,  check all wiring and connec-
tions to that switch and/or test switch (see Component
Testing in this chapter). Replace any defective switches
and repair any damaged wiring.
8.
After input functions testing is complete, disconnect
the Diagnostic Display connector from the harness con-
nector and plug loopback connector into wire harness.
Secure controller cover to machine.
Figure 10
Groundsmaster 4100--D/4110--D
Page 5 -- 7
Electrical System
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags, , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 340 pages
Document TypeService Manual
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website