Hi/Low Speed and Headlight (Groundsmaster 4110--D) Switches
The Hi/Low speed and headlight switches (Ground-
smaster 4110--D) are identical, two (2) position rocker
switches that are located on the control console.
6. After testing is completed, connect wire harness
connector to the switch.
7.
Assemble console arm (see Console Arm Assembly
TheHi/Lowspeedswitch (Fig.28)isusedasaninputfor
the TEC--5002 controller to set the machine traction
speed for Hi speed (2WD) or Low speed (4WD).
in the Service and Repairs section of Chapter 7 -- Chas-
sis).
TheGroundsmaster4110--Dheadlightswitchallowsthe
headlights to be turned on and off.
NOTE: Before disconnecting the Hi/Low speed switch
for testing, the switch and its circuit wiring should be
tested as a TEC--5002 input with the Diagnostic Display
(see Diagnostic Display in the Troubleshooting section
ofthischapter).IftheDiagnostic Displayverifies thatthe
Hi/Low speed switch and circuit wiring are functioning
correctly, no further switch testing is necessary. If, how-
ever, the Display determines that the Hi/Low speed
switch and circuit wiring are not functioning correctly,
proceed with test.
2
1
Testing
Figure 28
1.
Make sure ignition switch is OFF. Remove key from
1.
Console arm
2. Hi/Low speed switch
ignition switch.
2.
thatistobetested(seeConsoleArmDisassembly inthe
Service and Repairs section of Chapter 7 -- Chassis).
Disassemble console arm to gain access to switch
3.
Disconnect harness electrical connector from the
switch.
4.
With the use of a multimeter (ohms setting), the
BACK OF SWITCH
switch functions may be tested to determine whether
continuity exists between the various terminals for each
switch position. The switch terminals are marked as
shown in Figure 29. The circuitry of the switch is shown
in the chart below. Verify continuity between switch ter-
minals. Replace switch if testing identifies a faulty
switch.
Figure 29
NOTE: Switch terminals 1, 4, 5 and 6 are not used on
Groundsmaster 4100--D and 4110--D machines.
SWITCH
POSITION
CIRCUIT 1
2 + 3
CIRCUIT 2
5 + 6
ON
OFF
2 + 1
5 + 4
5.
If switch tests correctly and circuit problem still ex-
ists, check wire harness (see Electrical Schematics and
Wire Harness Drawings in Chapter 10 -- Foldout Draw-
ings).
Electrical System
Page 5 -- 26
Groundsmaster 4100--D/4110--D
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Groundsmaster 10177SL, Toro Groundsmaster 30447, Toro Groundsmaster 30449, Toro Groundsmaster 4100, Toro Groundsmaster 4110 D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)