Troubleshooting
There are a number of factors that can contribute to un-
satisfactory quality of cut, some of which may be turf
conditions. Turf conditions such as excessive thatch,
“sponginess” or attempting to cut off too much grass
height may not always be overcome by adjusting the
machine. It is important to remember that the lower the
height–of–cut, the more critical these factors are.
Remember that the “effective” or actual height–of–cut
depends on cutting unit weight and turf conditions. Ef-
fective height–of–cut will be different than the bench set
height–of–cut.
For additional information regarding cutting unit trouble-
shooting, see Aftercut Appearance Troubleshooting Aid
(Toro part no. 00076SL).
Factors That Can Affect Quality Of Cut
Factor
Possible Problem/Correction
1.
2.
Engine maximum governed speed.
Reel speed and ground speed.
Check maximum governed engine speed. Adjust
speed to specifications if necessary. If engine is not
running at specified maximum governed RPM, reel
speed settings may not match ground speed.
Adjust reel speed to setting shown on REEL SPEED
SELECTION CHART for the number of reel blades (5
or 8) and the desired ground speed (see Traction Unit
Operator’s Manual).
All reels should rotate at the same speed. All cutting
units should have equal bedknife to reel contact. If
checking RPM, do not run reel too long without cutting
grass, or bedknife and/or reel may overheat and “rifle”.
See other items in Troubleshooting section of Chapter
4
– Hydraulic System.
3.
4.
5.
Tire pressure.
Check each tire’s pressure. Adjust to pressures
specified in Specifications section of Chapter 6 –
Chassis.
Reel bearing condition.
Reel and bedknife sharpness.
All reels should rotate freely. Make sure bearings are
properly lubricated. Replace bearings if worn or
damaged.
Reel and/or bedknife that has rounded cutting edges or
“rifling” cannot be corrected by tightening bedknife to
reel contact. Grind reel to remove taper and/or rifling
(grooved or wavy appearance). Grind bedknife to
sharpen and/or remove rifling. (Most common cause of
rifling is bedknife to reel contact that is too tight.)
NOTE: New bedknife must be ground or backlapped
after installing on bedbar.
Cutting Units
Page 7 – 6
Reelmaster 2000–D
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Reelmaster 2000-D |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5) Lawn and Garden readers have rated Toro 02103SL Rev A Reelmaster 2000 D Service Manual 5.0 out of 5.0 based on 1 product reviews.
Really needed this manual. Amazing that Toro would make it so easily available. Full of details.