Transaxle
Removal
5
1.
Park machine on a level surface, stop engine, set
parking brake, and remove key from the ignition switch.
3
2.
Remove cargo box from the frame (see Cargo Box
Removal in Chapter 7 – Chassis, Wheels, and Brakes).
3.
Remove drive belt from the driven clutch (see Ser-
vice Drive Belt in Engine Chapter).
1
4
4.
Remove tie wraps securing both battery cables to
the passenger side axle tube.
2
5.
axle as follows (Fig. 21).
Remove governor and cable brackets from the trans-
Figure 21
4.
5.
1.
2.
3.
Scribe mark
Governor bracket
Set screw
Lock nuts
Cable bracket
A. Scribe mark across governor bracket and gover-
nor shaft to help reinstallation. Loosen both set
screws securing the bracket to the shaft.
2
1
B. Remove both lock nuts securing the cable brack-
et to the transaxle case. Remove both brackets and
cables as a complete unit from the transaxle case
and governor shaft.
2
6.
Remove lock nut securing the select lever assembly
4
to the selector shaft. Loosen jam nuts securing both shift
cables to the cable bracket. Separate select lever as-
sembly and shift cables from the transaxle (Fig. 22).
3
WARNING
Figure 22
1.
2.
Select lever assembly
3.
4.
Lock nut
Cable bracket
Shift cable
Before jacking up the machine, review and follow
Jacking Instructions in Chapter 1 – Safety.
4
6
5
7.
Jack up both sides of the frame (at the jacking point
indicated) enough to remove rear wheels (Fig. 23).
A. Chock the front and rear of both front tires to pre-
vent the vehicle from moving.
B. Support both sides of the frame with jackstands
positioned just in front of the axle tubes. This will al-
low the transaxle to be removed from the rear of the
vehicle.
3
2
7
1
8
JACKING POINT
8.
Remove both wheels and brake assemblies from the
transaxle (see Rear Wheel and Brake Removal in Chap-
ter 7 – Chassis, Wheels, and Brakes).
Figure 23
1.
2.
3.
4.
Flange lock nut
Flat washer
Isolation mount
Cap screw
5.
6.
7.
8.
Rear frame
Flange lock nut
Hex head flange screw
Transaxle
9.
Attach hoist or chain fall to the engine mount to lower
the engine and transaxle. Make sure lifting device is at-
tached to hold the full weight of the engine and mount.
Drive Train
Page 5 – 16
Workman 1100/2100/2110
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Workman 1100, Toro Workman 1110, Toro Workman 2100, Toro Workman 2110 |
| Download File |
|
| Document Type | Catalog |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)