Removal (Fig. 6)
Installation (Fig. 6)
NOTE: Make sure engine and exhaust header sealing
surfaces are free of debris or damage that may prevent
a tight seal.
CAUTION
The muffler and exhaust pipe may be hot. To
avoid possible burns, allow the engine and ex-
haust system to cool before working on the ex-
haust system.
IMPORTANT: Finger tighten all exhaust system fas-
teners before securing so there is no preload on ex-
haust components.
1.
gine. Position header pipe to the engine and install four
(4)
2.
Place exhaust gaskets on the exhaust studs on en-
1.
Park machine on a level surface, stop engine, en-
gage parking brake, and remove key from the ignition
switch.
flange nuts.
Position header pipe to header support with clamp
2.
muffler/tailpipe section of the exhaust system:
Gaining access from below machine, remove the
and two (2) flange nuts.
3.
Tighten fasteners to secure header pipe:
A. Loosen muffler clamp (item 15) that secures muf-
fler/tailpipe to header pipe.
A. Four (4) flange nuts to secure header pipe to en-
gine.
B. Remove two (2) flange nuts and clamp that se-
cure the muffler/tailpipe to muffler hanger.
B. Two (2) flange nuts on clamp to secure header
pipe to header support.
C. Slide muffler/tailpipe from header pipe and lower
muffler/tailpipe from machine.
4. Install lower exhaust shield (item 17), muffler heat
shield (item 19), and upper exhaust shield (item 16). Se-
cure shields with cap screws.
3.
Remove cap screws to allow removal of upper ex-
haust shield (item 16), muffler heat shield (item 19), and
lower exhaust shield (item 17).
5. Install the muffler/tailpipe section of the exhaust sys-
tem:
4.
Remove two (2) flange nuts and clamp that secure
the header pipe to the header support.
A. Place muffler clamp (item 15) on muffler/tailpipe
and slide muffler/tailpipe onto header pipe.
5.
Remove four (4) flange nuts from the exhaust studs
on engine. Remove header pipe from the engine.
B. Position muffler/tailpipe to muffler hanger with
muffler clamp and two (2) flange nuts.
6.
Remove exhaust gaskets from engine. Replace gas-
kets if damaged or torn.
C. Tighten muffler clamps to secure muffler/tailpipe.
Multi Pro 1200/1250
Page 3 – 9
Kohler Gasoline Engine
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Multi Pro 1200, Toro Multi Pro 1250 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)