Engine Removal (Fig. 13)
Remove engine mounting plate assembly from ma-
chine (see Engine Mounting Plate Removal in this sec-
tion).
Engine Installation (Fig. 13)
1.
1. Make sure that all parts removed from the engine
during maintenance or rebuilding are reinstalled to the
engine.
2.
Loosen CVT drive belt guides. Rotate driven clutch
2. If steering pump pulley was removed from engine,
position key into keyway of engine shaft. Apply anti–
seize lubricant to shaft and key. Assemble pump pulley
over key and shaft with hub on pulley away from engine.
and route drive belt over the driven clutch. Remove belt
from the drive clutch (see Drive Belt Service in Service
and Repairs Section of Chapter 7 – Drive Train).
3.
drive belt from pulleys.
Loosen hydraulic steering pump and remove pump
3. If drive clutch was removed from engine, reinstall
clutch to engine (see Drive Clutch in the Service and Re-
pairs Section of Chapter 7 – Drive Train).
4.
Loosen and remove three (3) remaining flange head
screws and flange nuts that secure engine to engine
mounting plate. Remove engine from mounting plate.
4. Secure engine to the mounting plate with three (3)
flange head screws and flange nuts. The flange head
screw position under the starter motor should not be
used because it is used to secure the negative (–) cable
to the engine.
5.
If needed, remove drive clutch from engine crank-
shaft (see Drive Clutch in the Service and Repairs Sec-
tion of Chapter 7 – Drive Train).
5.
Install steering pump drive belt to pump pulleys.
6.
pump pulley from engine crankshaft. Locate and re-
trieve key.
If needed, loosen set screws and remove steering
Position pump pulley on engine so pulleys are aligned.
Apply Loctite #242 (or equivalent) to pulley set screws
and secure pump pulley to engine crankshaft with set
screws. Adjust pump drive belt tension (see Operator’s
Manual).
6.
Place CVT drive belt around drive clutch. Rotate
driven clutch while routing the belt onto the driven
clutch. Adjust belt guides (see Drive Belt Service in Ser-
vice and Repairs Section of Chapter 7 – Drive Train).
7.
Install engine mounting plate to machine (see En-
gine Mounting Plate Installation in this section).
Multi Pro 1200/1250
Page 3 – 15
Kohler Gasoline Engine
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Multi Pro 1200, Toro Multi Pro 1250 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)