Removal (Fig. 85)
Installation (Fig. 85)
NOTE: The ports on the manifold are marked for easy
identification of components. Example: SV1 is the deck
solenoid valve and P1 is a gear pump connection port.
(See Hydraulic Schematic in Chapter 9 -- Foldout Draw-
ingstoidentifythefunctionofthehydrauliclinesandcar-
tridge valves at each port).
1. If fittings were removed from manifold, lubricate and
place new O--rings onto fittings. Install fittings into man-
ifold openings using marks made during the removal
process to properly orientate fittings. Tighten fittings
(see Hydraulic Fitting Installation in the General Infor-
mation section of this chapter).
The control manifolds for the three (3) cutting deck sec-
tions are very similar.
2. Install hydraulic manifold to the frame using Figure
85 as guide.
IMPORTANT: Whenservicingthedeckcontrolman-
ifolds, DO NOT interchange parts from one control
manifold to another.
3. Remove caps and plugs from fittings and hoses.
Properly connect hydraulic lines to manifold.
4.
Connect electrical connector to the solenoid valve.
1.
Installing Hydraulic System Components at the begin-
ning of this section.
Read the General Precautions for Removing and
2.
manifold removal, thoroughly clean exterior of manifold
and fittings.
To prevent contamination of hydraulic system during
3.
Disconnect electrical connector from the solenoid
valve.
4.
caps or plugs on open hydraulic lines and fittings. Label
disconnected hydraulic lines for proper installation.
Disconnect hydraulic lines from manifold and put
5.
Remove hydraulic manifold from the frame using
Figure 85 as guide.
6.
mark fitting orientation to allow correct assembly. Re-
move fittings from manifold and discard O--rings.
If hydraulic fittings are to be removed from manifold,
Groundsmaster 4100--D
Page 4 -- 119
Hydraulic System
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Groundsmaster 30413, Toro Groundsmaster Groundsmaster 4100 D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)
At only 700mm wide the Mini Dumper is even at home on tight access
sites. No need to grunt, groan, and force the
mower about the yard. The US will be getting a revised 2011 Jeep Wrangler but the diesel option will not be offered in the United States.