Adjust Rear Lift Arm
1.
Park machine on alevel surface and engage parking
brake.
IMPORTANT: This adjustment must be performed
withtherearcuttingunitattachedtotherearliftarm.
2
2.
Raise lift arms. Make sure clearance between wear
strap on the top of the rear cutting unit wear bar and
bumper strap is from .020 to .100 inch (0.51 to 2.54 mm)
(Fig. 7).
1
Figure 7
1.
Wear bar
2.
Bumper strap
3.
If the clearance is not in this range, attain proper
clearance by adjusting the rear hydraulic cylinder as fol-
lows (Fig. 8):
1
2
A. Lower cutting units, turn engine off, and remove
key from the ignition switch.
B. Back off jam nut from the rear hydraulic cylinder
clevis.
IMPORTANT: Use a protective covering around the
hydraulic cylinder rod when rotating the rod to pre-
vent damage to the rod.
C. Graspcylinderrodnearthejamnutandrotatethe
rod.
D. Raise cutting units and check clearance. Repeat
steps A through C as necessary. Tighten jam nut on
hydraulic cylinder rod when clearance is correct.
Figure 8
1.
Rear hydraulic cylinder
2.
Jam nut
NOTE: If rear lift arm makes clunking noises during
transport, the clearance can be reduced.
IMPORTANT: The lack of clearance at the rear wear
bar can damage the rear lift arm.
Wheels, Brakes, and Chassis
Page 6 -- 6
Groundsmaster 3500--D
Product Specification
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Groundsmaster 3500 D |
Download File |
|
Document Type | Catalog |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |